R-Tech I-CUT100P Bedienerhandbuch

PLASMA CUT40 Inverter Air Plasma ManualUNI FLAME AUTOLIFTMAXIMUM CUTTING CAPACITY 10MMMILD STEELPlasma CUT240 Volt

UNI FLAME AUTOLIFT11043251213 Spare Parts No Description WGA Part No. 1 Front panel J02042 2 Cover J03235 3 Handle J24005 4 Knob C16001 5

21aFront end consumables Spare Parts No WGA Part No. Description 1 07035 70° Torch head 3 07103 Handgrip complete with microswitch 4 5

WELDING GUNS OF AUSTRALIA Pty Ltd WWW.UNIMIG.COM.AUDisclaimer:While the information is provided in good faith, Welding Guns Of Australia does not warr

Machine ModelDescription Part Number Plasma Cut 40 KUPJR40 CONTENTS PAGE No:Safety 3General Description 4Curcuit Diagram 5Main Parameter 6Install

• Do not switch the function modes while the machine is operating. Switching of the function modes during welding can damage the machine. Damage cause

UNI FLAME AUTOLIFTThe plasma cutting unit generates constant current and has been designed to cut metals. The cutting process is carried out through

UNI FLAME AUTOLIFT3. CIRCUIT DIAGRAMSingle Phase Input

Machine ModelDescription Part Number Plasma Cut 40 KUPJR40Tecnical SpecificationMAIN PARAMETERInput voltage (V)Input Frequency (Hz)Input capacitance

UNI FLAME AUTOLIFTINSTALLATION & OPERATIONINSTALLATION AND OPERATIONIn order for the unit to function correctly, it must be installed properly. F

CAUTION:Do not point the torch jet at foreign bodiesCAUTION:Avoid unnecessary lighting of the pilot arc to prevent excessive consumption of the electr

UNI FLAME AUTOLIFTOPERATIONOf the torchCAUTION:Before inspecting or changing the parts of the torch, disconnect the power supply to the unit. Special